REFRIGERATOR INSTALLATION
12
NOTE
: Removing the doors is always recommended when it is necessary to move the refrigerator through a narrow
opening. If it is necessary to remove the handles, follow the directions below.
REMOVING AND REPLACING HANDLES
CONTINUED
NOTE
: Handle appearance may vary from the illustrations
on this page.
Removing Freezer Drawer Handle
Loosen the set screws located on the lower side of
the handle with a
ê
in. Allen wrench and remove the
handle.
NOTE
: If the handle mounting fasteners need to be
tightened or removed, use a ¼ in. Allen wrench.
Replacing Freezer Drawer Handle
Place the handle on the door by
o
tting the handle
footprints over the mounting fasteners and tightening
the set screws with a
ê
in. Allen wrench.
NOTE
: If the handle mounting fasteners need to be
tightened or removed, use a ¼ in. Allen wrench.
WARNING
When assembling or disassembling the handles:
v
Grasp the handle
o
rmly to ensure it will not drop or
cause injury.
v
Prevent the handle from swinging toward nearby
people or animals.
v
Insert the bracket hole of the handle into the
stopper bolt of the door exactly, then assemble the
set screws to
o
x the handle in place.
v
Check for any gap between the door and handle
after the handle is
o
xed in place.
