![background image](http://html2.mh-extra.com/html/keithley/system-sourcemeter-2601b/system-sourcemeter-2601b_reference-manual_4009934262.webp)
Section 5: Introduction to TSP operation
Series 2600B System SourceMeter® Instrument Reference Manual
5-8
2600BS-901-01 Rev. B / May 2013
LAN and LXI
The LAN commands have options that allow you to review and configure network settings.
The
lan.config.*
commands allow you to configure LAN settings over the remote interface. Note
that you must send
lan.applysettings()
for the configuration settings to take effect.
The
lan.status.*
commands help you determine the status of the LAN.
The
lan.trigger[
N
].*
commands allow you to set up and assert trigger events that are sent over
the LAN.
Other LAN commands allow you to reset the LAN, restore defaults, check LXI domain information,
and enable or disable the Nagle algorithm.
lan.applysettings()
(on page 7-111)
lan.autoconnect
(on page 7-112)
lan.config.dns.address[N]
(on page 7-112)
lan.config.dns.domain
(on page 7-113)
lan.config.dns.dynamic
(on page 7-114)
lan.config.dns.hostname
(on page 7-114)
lan.config.dns.verify
(on page 7-115)
lan.config.duplex
lan.config.gateway
(on page 7-116)
lan.config.ipaddress
(on page 7-117)
lan.config.method
(on page 7-117)
lan.config.speed
(on page 7-118)
lan.config.subnetmask
(on page 7-118)
lan.linktimeout
(on page 7-119)
lan.lxidomain
(on page 7-120)
lan.nagle
(on page 7-120)
lan.reset()
(on page 7-121)
lan.restoredefaults()
(on page 7-121)
lan.status.dns.address[N]
(on page 7-122)
lan.status.dns.name
(on page 7-122)
lan.status.duplex
lan.status.gateway
(on page 7-123)
lan.status.ipaddress
(on page 7-124)
lan.status.macaddress
(on page 7-124)
lan.status.port.dst
(on page 7-125)
lan.status.port.rawsocket
(on page 7-125)
lan.status.port.telnet
(on page 7-126)
lan.status.port.vxi11
(on page 7-126)
lan.status.speed
(on page 7-127)
lan.status.subnetmask
(on page 7-127)
lan.timedwait
(on page 7-128)
lan.trigger[N].assert()
(on page 7-128)
lan.trigger[N].clear()
(on page 7-129)
lan.trigger[N].connect()
(on page 7-130)
lan.trigger[N].connected
(on page 7-130)
lan.trigger[N].disconnect()
lan.trigger[N].EVENT_ID
(on page 7-131)
lan.trigger[N].ipaddress
(on page 7-132)
lan.trigger[N].mode
(on page 7-133)
lan.trigger[N].overrun
(on page 7-134)
lan.trigger[N].protocol
(on page 7-134)
lan.trigger[N].pseudostate
lan.trigger[N].stimulus
(on page 7-135)
lan.trigger[N].wait()
localnode.description
(on page 7-138)
localnode.password
(on page 7-140)
Summary of Contents for System SourceMeter 2601B
Page 841: ......