Series 2600B System SourceMeter® Instrument Reference Manual
Section 7: TSP command reference
2600BS-901-01 Rev. B / May 2013
7-121
lan.reset()
This function resets the LAN interface.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
lan.reset()
Details
This function resets the LAN interface. It performs the commands
lan.restoredefaults()
and
lan.applysettings()
.
Also see
lan.applysettings()
(on page 7-111)
lan.restoredefaults()
(on page 7-121)
lan.restoredefaults()
This function resets LAN settings to default values.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
lan.restoredefaults()
Details
The settings that are restored are shown in the following table.
Settings that are restored to default
Attribute
Default setting
lan.autoconnect
lan.ENABLE
lan.config.dns.address[N]
"0.0.0.0"
lan.config.dns.domain
""
lan.config.dns.dynamic
lan.ENABLE
lan.config.dns.hostname
""
lan.config.dns.verify
lan.ENABLE
lan.config.duplex
lan.FULL
lan.config.gateway
"0.0.0.0"
lan.config.ipaddress
"0.0.0.0"
lan.config.method
lan.AUTO
lan.config.speed
100
lan.config.subnetmask
"255.255.255.0"
lan.linktimeout
20
(seconds)
lan.lxidomain
0
lan.nagle
lan.ENABLE
lan.timedwait
20
(seconds)
This command is run when
lan.reset()
is sent.
Summary of Contents for System SourceMeter 2601B
Page 841: ......