Keithley SourceMeter 2400, Service Manual, Page: 112 / 137

B-2 Command Reference
Introduction
This appendix contains detailed information on the various Model 2400 remote calibration
commands, calibration error messages, and methods to detect the end of each calibration step.
Section 2 of this manual covers detailed calibration procedures.
Command summary
Table B-1 summarizes Model 2400 calibration commands. These commands are covered in
detail in the following paragraphs.
Table B-1
Remote calibration command summary
Command Description
CALibration
:PROTected
:CODE '<password>'
:COUNT?
:SAVE
:LOCK
:LOCK?
:DATE <y>,<m>,<d>
:DATE?
:NDUE <y>,<m>,<d>
:NDUE?
:SENSe <nrf>
:DATA?
:SOURce <nrf>
:DATA?
Calibration subsystem.
Cal commands protected by password.
Unlock cal. If cal is unlocked, changes password. (Default password:
KI002400.)
Query number of times 2400 has been calibrated.
Save calibration data to EEPROM.*
Lock calibration, inhibit SAVE command operation.
Request cal lock status. (0 = unlocked; 1 = locked)
Program calibration year, month, day.
Query calibration year, month, day.
Program calibration due year, month, day.
Query calibration due year, month, day.
Calibrate active measure range.
Query measurement cal constants for active range.
Calibrate active source range.
Query source cal constants for active range.
*Calibration data will not be saved if:
1. Calibration was not unlocked with :CODE command.
2. Invalid data exists. (For example, cal step failed, or was aborted.)
3. Incomplete number of cal steps was performed. (For example, omitting a negative full-scale step.)