9
45.
Press Enter to enable channel 3 and output channel 3’s configured voltage.
46.
Press Esc a couple of times to return to the main display.
STEP 6 Disabling Channel 3
47.
Press Menu.
48.
Use the arrow keys, or the navigation wheel to select
Enable Channels
.
49.
Press Enter to enter the submenu.
50.
Use the arrow keys, or the navigation wheel to select
Enable/Disable CH3
.
51.
Press Enter to enter the submenu.
52.
Use the arrow keys, or the navigation wheel to select
Disable CH3
.
53.
Press Enter to disable channel 3 and turn off channel 3’s output voltage.
54.
Press Esc a couple of times to return to the main display.
STEP 7 Disabling Channel 2
55.
Press Menu.
56.
Use the arrow keys, or the navigation wheel to select
Enable Channels
.
57.
Press Enter to enter the submenu.
58.
Use the arrow keys, or the navigation wheel to select
Enable/Disable CH2
.
59.
Press Enter to enter the submenu.
60.
Use the arrow keys, or the navigation wheel to select
Disable CH2
.
61.
Press Enter to disable channel 2 and turn off channel 2’s output voltage.
62.
Press Esc a couple of times to return to the main display.
STEP 8 Disabling Channel 1
63.
Press Menu.
64.
Use the arrow keys, or the navigation wheel to select
Enable Channels
.
65.
Press Enter to enter the submenu.
66.
Use the arrow keys, or the navigation wheel to select
Enable/Disable CH1
.
67.
Press Enter to enter the submenu.
68.
Use the arrow keys, or the navigation wheel to select
Disable CH1
.
69.
Press Enter to disable channel 1 and turn off channel 1’s output voltage.
70.
Press Esc a couple of times to return to the main display.
Remote Operation
The following SCPI command example assumes that all channels are disabled. The command sequence
sets the voltage output to 3V, 9V and 5V on CH1, CH2 and CH3, respectively, sets all the current limits to
1.5A, turns the output on sequentially from CH1 to CH2 to CH3 and turns off each output from CH3 to
CH2 to CH1.
INST:SEL CH1
SOURCE:VOLT 3V
SOURCE:CURR 1.5A
INST:SEL CH2
SOURCE:VOLT 9V
SOURCE:CURR 1.5A
