3-1
3
Setup and Installation
This chapter contains instructions for installing the DDA-06 board. The
installation task includes three basic steps: unpacking and inspecting the
board, setting the configuration switches and jumpers, and installing the
board in the computer. These steps are described in the sections that
follow.
Unpacking and Inspecting
Caution:
A discharge of static electricity from your hands can seriously
damage certain electrical components on any circuit board. Before
handling any board, discharge static electricity from yourself by touching
a grounded conductor such as your computer chassis (your computer
must be turned off) or by wearing an anti-static strap. Whenever you
handle a board, hold it by the edges and avoid touching any board
components.
Use the following procedure to unwrap and inspect a DDA-06 board.
1. Factory packaging of the DDA-06 board includes a final wrap of
protective, anti-static material. Remove the board from its anti-static
wrapping material. You may wish to store the wrapping material for
possible future use.
2. Inspect the board for signs of damage. If damage is apparent, arrange
to return the board to the factory (see “Technical Support” on page
8-5).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com