Keithley 7001, Instruction Manual, Page: 234 / 353

IEEE-488 Reference
5-115
Line 10 Enables all SCPI defined messages.
Line 20 Addresses the Model 7001 to talk.
Line 30 Displays the enable messages (0:-999).
:DISable <list>
:STATus:QUEue:DISable <list> Disable messages for Error Queue
<list> = (numlist)
where; numlist is a specified list of messages that you wish to disable for the Error Queue.
:stat:que:dis (numlist)
Power-up Disable status events, enable error events
*CLS No effect
:STATus:PRESet Disable status events, enable error events
:DISable? Query list of disabled messages
Short-form format: :stat:que:dis?
Response message: numlist
On power-up, all error messages are enabled and will go into the Error Queue as they occur.
Status messages are not enabled and will not go into the queue. This command is used to specify
which messages you want disabled. Disabled messages are prevented from going into the Error
Queue.
Messages are specified by numbers (see Table 4-1). The following examples show various forms
for expressing a message numlist:
Numlist = -110 Single message.
= -110, -140, -222 Messages separated by commas.
= -110:-222 Range of messages (-100 through -222).
= -110:-222, -230 Range entry and single entry separated by a comma.
10 OUTPUT 707; “:stat:que:dis (-140:-150); dis?”
20 ENTER 707; A$
30 PRINT A$
40 END
Line 10 Disables messages -140 through -150.
Line 20 Addresses the Model 7001 to talk.
Line 30 Displays the disabled messages (-140:-150).
Parameters
Short-form
format
Defaults
Query
commands
Description
Programming
example
:STATus Subsystem
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com