1
5.4 Front shield
1. Determine dimensions (Figure 44).
The width is equal to the inner trailer width. The front shield is angled about 45
degrees. When the floor slats/planks are in the rear position, the slide strip must
still lie fully on top of the floor slats/planks.
2. Fabricate front shield. (KEITH Mfg. Co. supplies this in most cases.)
Form the plate and attach angle steel for support. Rivet the plastic slide strip to
the shield.
3. Mount front shield.
Screw the plate to the side of the trailer.
Provide clean-out holes below the slope sheet.
25027
Figure 44
Summary of Contents for Running Floor II Metric
Page 31: ...Figure 38 Figure 37 50mm...
Page 40: ...25044 Figure 45...