e. Pull the seal flush with the end of the slat/plank. Install the anchor screw
(Figure 39). Do not tighten the anchor screw too tightly. Allow the adhesive to
dry before finishing the installation of the slat/plank.
f. Apply three additional beads of adhesive. The additional beads of adhesive
should be 610mm long. The additional beads should be located at 1/4 of the
slat/plank length, 1/2 of the slat length, and 3/4 of the slat length. The
additional beads may be applied after the seal is installed (Figure 40).
Figure 40
Figure 39
610mm LONG
610mm LONG
610mm LONG
Summary of Contents for Running Floor II Metric
Page 31: ...Figure 38 Figure 37 50mm...
Page 40: ...25044 Figure 45...