25045
Height
a. Place plastic bearings on 25mm x 25mm tube at sides and center of trailer at
each end of drive area.
b. Lay a straight edge from bearing to bearing across the drive.
c. Raise the drive so the top of the drive shoe touches the straight edge across
the shoe length on each straight edge. The 6mm dimension from the top of
the 25mm x 25mm tube to the top of the drive shoe is critical. Make height
adjustments by shimming or grinding ears of the drive unit end plates.
This method gives the proper drive height as bearings are 6mm above the 25mm
x 25mm tube and the drive shoes connect directly to floor slats/planks (Figure
23).
25035
3. Weld the drive unit in place.
Weld according to reference drawing C-10797A. Remember to connect
25mm x 25mm tubing to the drive unit's formed cross sill.
4. Weld bracing to side walls as shown in reference drawing C-10797A.
5. Install cross-drive support tubes as shown in reference drawing C-10797A.
Figure 21
Figure 23
25mm x 25mm
6mm
Summary of Contents for Running Floor II Metric
Page 31: ...Figure 38 Figure 37 50mm...
Page 40: ...25044 Figure 45...