27
DOC06820 Rev. A
SERVICE / REPAIR MANUAL
RUNNING FLOOR II
®
DX
6. Loosen the tube nuts on the opposite side of
the control valve.
7. Remove the bolts attaching the control valve to
the drive frame and remove the control valve.
8. Plug the remaining tube ends to keep them
clean and from leaking fluid.
Control Valve Installation:
9.
Install the new control valve and torque the (4) bolts. (See Bolt Torque Requirements)
10.
Remove the plugs from the tube ends, reconnect the tubes and tighten (See Service Information chart).
11.
Run the floor and check for leaks.
7
7
8
8
8
8
