29
DOC06179 Rev. B
OWNER / OPERATOR MANUAL
RUNNING FLOOR II
®
DX / DXE
3.11 Manual Override of Electric Controls
In the case of a malfunction in the electrical system or loss of the remote control, the electric valves can still
be operated by activating the manual override fitted for that purpose.
1. Before operating, follow the Pre-Trip Check List.
2. Open truck or trailer doors fully and secure doors with provided chains or loop rings.
⚠
CAUTION: ALWAYS have doors fully open! Do not, under any circumstances, engage the Power
Take Off (PTO) / Pump System or
WALKING FLOOR
® unloader with the doors of the truck or trailer
closed. Catastrophic failure to the trailer, as well as serious injury or death may occur.
3.
Inspect hydraulic hoses and quick connects for damage, then connect the floor to the truck wet
kit (If applicable).
4.
Engage the PTO, then bring the truck engine up to the RPM to achieve desired flow rate from the
wet kit.
5.
Determine if the floor is in the load or unload mode. The typical position of the solenoid is in the
unload position. If the floor is in the loading mode, take off the protective plastic cap. Push the
red button in (1) and turn it a half turn counter clockwise (2). Release the red button and it will
pop out.
1
2
Manual Override - Control Valve (solenoid)
Summary of Contents for KRFII-3
