28
DOC06179 Rev. B
OWNER / OPERATOR MANUAL
RUNNING FLOOR II
®
DX / DXE
3.10 Electric On/Off & Electric Load/Unload - Cabled Remote Control
1. Before operating, follow the Pre-Trip Check List.
2. Open truck or trailer doors fully and secure doors with
provided chains or loop rings.
⚠
CAUTION: ALWAYS have doors fully open! Do not, under any
circumstances, engage the Power Take Off (PTO) / Pump System or
WALKING FLOOR
® unloader with the doors of the truck or trailer
closed. Catastrophic failure to the trailer, as well as serious injury
or death may occur.
3. Inspect hydraulic hoses and quick connects for damage,
then connect the floor to the truck wet kit (If applicable).
4. Engage the PTO, then bring the truck engine up to the
RPM to achieve desired flow rate from the wet kit.
5. Turn on the electric power to operate the remote control.
6. Turn ON the remote by twisting the EMS button clockwise
to disengage the EMS (emergency stop) button. (The
button will pop up.)
7. Now the remote control is ready for use.
UNLOAD:
Push and release the Up button on the control. The floor will continue to move until
the Up button is pushed again.
LOAD:
Push and hold the Down button. The floor will move until the button is released.
⚠
CAUTION: While unloading, NEVER leave truck and trailer unattended.
⚠
WARNING: Do not go under the truck or trailer body or enter the truck or trailer while the system is
in operation, nor allow anyone to stand or move through the area where the load is being discharged.
Burial, loss of limb or life may occur.
8.
After loading/unloading has been completed, stop the floor with all slats in the forward position,
turn off the remote control by pushing the EMS button.
9. Turn off the electric power to the remote control.
10. Disengage PTO and return the truck engine to idle.
11. Close and secure the truck or trailer doors.
12. Disconnect and secure the hydraulic hoses (If applicable).
EMERGENCY STOP:
In case of emergency the floor can be stopped in one of the following ways:
• Push the red EMS (emergency stop) button on the remote
• Disengage the PTO / Pumping System.
Emergency
STOP Button
(EMS)
UNLOAD Button
(Push Up)
LOAD Button
(Push Down)
Summary of Contents for KRFII-3
