All Off
- None of the LEDs will light. The Keyboard LEDs will not respond to Remote LED
Control. LEDs will still light up normally in Preset Select and Live Edit Modes.
LED Refresh Mode saves in the preset so make sure to save and send your preset to QuNexus
in order for this option to take effect. All of the Factory Presets use Normal mode.
For information about the
Per Key Sensitivities
option see the
Per Key Sensitivities
chapter.
For information about the
CV Trims
option see the
CV Trims
chapter.
For information about the
Tables
option see the
View/Edit Tables
chapter.
The Help menu’s
Documentation
will open the QuNexus
Manual.
There is also an option to Hide or Show Tool Tips.
Tool Tips
are
quick, helpful descriptions that pop up if the mouse hovers over
certain parameters in the Editor. Not all parameters have Tool
Tips.
3.7 Sensitivity
There are Sensitivity controls just above the tabs. Here you can adjust the Sensitivity, On and
Off Thresholds, and the Tilt Sensitivity. These are global for the entire keyboard but can be set
differently for each preset.
Sensitivity
controls how easy it is to get higher value ranges when controlling pressure and
velocity. The higher the sensitivity, the easier it will be to reach the upper range of values. The
lower the sensitivity, the more difficult or impossible it will be to get higher value ranges.
On Thresh
controls the pressure value at which a note on will register. Example: If set to 10, the
Slider pressure has to reach a value of 10 before a note on is sent.
Off Thresh
controls the pressure value at which a note off will register. Example: If set to 5, the
Slider pressure would have to be 5 or lower for a note off to register. This cannot be set higher
than the on threshold.
Tilt Sens.
controls how easy it is to activate the Tilt source. By default, Tilt requires an
intentional pressure shift/tilt of your finger to engage. This makes it easier to activate Tilt only
when you want to. The higher the value of Tilt Sens., the easier it is to activate Tilt.
36
