M7i WHEELCHAIR-ACCESSIBLE TOTAL BODY TRAINER
10
BLUETOOTH
®
smart
*
To receive and download workout information from your M7i to any Bluetooth
®
smart
* Ready device, a machine
ID number is required. The following is a one-time machine ID setup procedure. NOTE: Steps 1 through 7 must be
completed within one minute.
Begin with the computer off and pull
Resistance Lever all the way down
towards you. This is GEAR “1” position.
Pedal 1 full revolution to change the
TIME value to “2”.
Shift the Resistance Lever from top
to bottom (GEAR “88” to GEAR “1”)
for a total of 6 times.
Pedal 1 full revolution to change the
TIME value to “1”.
Shift the Resistance Lever down to
GEAR “19”.
Upon successful completion of
Steps 1–7, “SET id” will appear on
the display. Proceed to Step 9 to
set ID number.
NOTE: If Steps 1–7 are not
completed within one minute,
allow the computer to shut down
(estimated time one minute) and
restart the procedure.
Shift the Resistance Lever up to
GEAR “21”.
Pedal 1 full revolution to change the
TIME value to “3”.
Move the Resistance Lever up to
increase, or down to decrease, the ID
number setting to any value between
1 and 199. Hold the ID number by
positioning the Resistance Lever to
any GEAR number between 8 and
16. Allow the computer to shut down
(estimated time one minute).
NOTE: The computer must shut down
to save and exit the Bluetooth
®
smart
*
setup mode.
1
1x
2
3
1x
4
1x
6
GEAR “1”
GEAR “88”
6x
7
9
GEAR 1 to 7
DECREASES
ID number
GEAR 8 to 16
HOLDS
ID number
GEAR 17 to 24
INCREASES
ID number
8
“SET id”
ID NUMBER
5
