555518_A
p9.
M3i INDOOR GROUP CYCLE
OPERATION
4. Attach the brackets on the end of the flywheel guard,
refer to Figure 8. Use the M6 x 45 hex head screw and
nut (supplied). Hand tighten the screw and nut.
5. Tighten the brackets to the base frame with the two
6mm Allen screws and washers removed in step 1. Do
not fully tighten the bolts.
6. Check to ensure that there is enough clearance between
the flywheel and the flywheel guard.
7. Tighten the bolts to secure the flywheel guard.
1. Unwrap the pedals and the thread locking compound.
2. Apply LPS#3 to the left bottom bracket bearing.
3. Apply LPS #3 to the clip-in portion of the pedals.
4. Clean the threads of the pedals with a clean cloth.
5. Apply thread locking compound to the pedal threads.
6. Use a 15mm open-end wrench and install the pedals:
Left Pedal
- Thread the left pedal (marked L) into the left side
of the left crank arm by turning it counter-clockwise,
refer to Figure 9.
Right Pedal
- Thread the right pedal (marked R) into the right
side of the right crank arm by turning it clockwise,
refer to Figure 10.
7. Tighten the pedals with a torque wrench, 15mm crowfoot,
and 4-inch extension. Torque the pedals to
45 Nm (35 ft-lbs).
INSTALLING THE PEDALS
WARNING: Failing to install the pedals with a thread locking compound, or crossing the threads will
damage them, and could result in serious injury to the user.
Figure 8. Align, Attach, and Tighten Flywheel Guard Brackets
Figure 10. Installing the Right Pedal, Turn Clockwise
Figure 9. Installing the Left Pedal, Turn Counter-Clockwise
NOTE: A torque wrench with a 15mm crowfoot and 4-inch extension, and a15mm open-end wrench are required to install the