555518_A
p19.
M3i INDOOR GROUP CYCLE
OPERATION
WARNING: Do not burn batteries. Do not place batteries in waste bins. Batteries must be
disposed of by a Licensed Waste Collector. Battery leakage is extremely caustic and contact with
bare skin should be avoided. In the event that battery leakage comes in contact with your skin,
flush the area for 15 minutes with copious amounts of water and seek medical attention. Gloves,
overalls, safety shoes and eye protectors must be used when handling leaking batteries. Follow
manufacturer’s recommendations when handling and maintaining batteries.
COMPUTER BATTERY REPLACEMENT
M SERIES CARDIO CALIBRATION
If the battery is low the Odometer (ODO) setting will display “LO-BA”.
To replace the batteries:
1. Remove the screw from the back of the computer housing.
2. Remove the old AA batteries.
3. Install two new AA batteries.
4. Replace the back to the computer housing and tighten the screw.
All M Series equipment is calibrated with a tool at the factory and there is no need to calibrate, unless a component
associated with the resistance mechanism or computer require service. For more information visit:
www.keiser.com/service
or contact the Keiser service department at
1-800-888-7009 | 559-256-8000 | [email protected].
Figure 27. Battery Compartment
COMPLIANCE
This machine complies with ISO 20957-1, and ISO 20957-10. Accuracy
class A, for high accuracy, and usage class S for professional and/or
commercial use.This cycle is intended for indoor use only.
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of
the device.
Le present appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisee aux deux conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioelectrique subi, meme si le brouillage est susceptible d’en
compromettre le fonctionnement.
REGULATORY NOTICE
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Keiser Corporation could void the user’s authority to operate the equipment.
REGULATOR AND COMPLIANCE NOTICES