555518_A
p4.
M3i INDOOR GROUP CYCLE
OPERATION
1. Carefully remove the cycle from the box.
2. Carefully unwrap the cycle.
3. Layout all the cycle components and compare them to the “Parts List” on page 5.
4. Check that all parts are present and undamaged.
NOTE: If parts are missing or damaged contact your local dealer, distributor or Keiser Corporation Service Department.
Thank you for purchasing Keiser’s premier M3i indoor cycle. Your new resistance system is a revolutionary way to
exercise providing a smoother, quieter, and more predictable workout.
The following tools are required to assemble the cycle but not supplied:
WARNING: Use caution when using a box cutter or other tool with a sharp blade to unwrap the
cycle. A sharp tool can cause damage to the seat, handlebars, or scratch the frame of the cycle.
INTRODUCTION
WEIGHT AND FOOTPRINT
TOOLS REQUIRED FOR ASSEMBLY
Total Weight
Qty
1
1
1
1
1
1
2
Qty
1
1
1
1
1
1
Description
Torque wrench (Minimum 45 Nm/35 ft-lb)
4-inch extension
15mm open-end wrench
16mm, or 5/8-inch open-end wrench
#2 Phillips screwdriver
15mm crow foot
10mm wrenches
Description
16mm, or 5/8-inch crowfoot
5mm Allen wrench
6mm Allen wrench
Paste or spray wax (used to clean after
assembly)
Clean cloth
LPS #3 heavy-duty rust inhibitor
with straw
91 lbs (41.27kg)
Length 58.5-inches (1485 mm) x
Width 25.75 in (654 mm)
M3i Footprint