CHECKING FOR PROPER OPERATION
�
All Parts Correctly Installed
�
Acorn Nuts Torqued to 47 Nm (35 ft-lbs)
�
Pedals Loctited and Torqued to 47 Nm (35 ft-lbs)
�
Foot Rests Loctited and Torqued to 47 Nm (35 ft-lbs)
�
Handle to Pivot Shaft Bolts Torqued to 23 Nm (17 ft-lbs)
�
Handle to Link Mount Bolts Torqued to 23 Nm (17 ft-lbs)
�
Seat Adjustment Operates Properly
�
Apply LPS #3 to flange and screws mounting TBT Main Frame (D) to Base Frame (C)
�
Apply LPS #3 to each side of both transport wheel bearings (Fig. 28)
�
Apply LPS #3 to the front end link bearing of both links (Fig 29a)
�
Apply LPS #3 to left bottom bracket bearing (Fig. 29b)
WARNING:
Perform the operations below before riding to make sure the TBT is fully
operational. Failing to test a bike prior to normal use will void your warranty and could
result in serious injury.
NOTE: Since we are always striving to improve our products;
our products are subject to change without notice.
28
29
b
a
�
TBT Has Been Polished With Paste or Spray Wax and a Clean Cloth
�
Computer Installed and Calibrated and in Working Order
( See M Series Computer Overview )
WARNING:
Failure to follow the below safety information and instructions could
result in personal injury or loss of life. Use this equipment only for its intended use as
described in this manual. Please read all the information provided for safe operation.
IMPORTANT SAFETY INFORMATION & INSTRUCTIONS
• The Keiser M3 TBT is NOT designed with a freewheel, but a fixed gear system. The
Handles are attached to the crank arms through the links and the eccentrics. The crank
arms and Handles can not be disengaged independently. When the flywheel is in motion,
both the pedals and the handles will also be in motion. Never remove your feet and/or let
them hang while in motion as serious user injury may occur. Never take your hands off
the Handles while in motion. Remain seated in the saddle at all times while operating the
M3 TBT. When utilizing the M3 TBT for independent upper body exercises, always place
your feet (arch, or heel section of foot) on the Foot Rests. Proper foot placement is
important to ensure clearance from the path of the moving pedals. Never adjust the
resistance shifter while the TBT is in motion. To raise or lower resistance levels, slowly
bring the motion of the Handles and/or Pedals to a controlled stop, adjust the resistance,
Summary of Contents for m3 TBT
Page 1: ...USER MANUAL ...
