M3i INDOOR GROUP CYCLE
10
(a) Position the front of the Main Frame facing the
Transport Wheels, then carefully lower the Main Frame
onto the Base over the Base Studs.
(b) Install one Washer and one Acorn Nut (Items B and A)
onto each Base Stud. Tighten Acorn Nuts using a 16 mm
(5/8 inch) Open-end Wrench. Torque to 35 ft-lbs (47 Nm)
using a 16 mm (5/8 inch) Crowfoot and Torque Wrench.
Prepare Base and Main Frame.
(a) Remove the Mount Screw using a #2 Phillips
Screwdriver. Carefully release the Computer Display
from the packing material.
(a)
Slide the Computer Mount up and under the Mount
Tabs. Align the screw holes and install the Mount Screw
(removed in Step 3) using a #2 Phillips Screwdriver.
(b) Tightly coil the Communication Wire into the
Computer Mount Cavity.
(b) Remove the two screws along the side of the Sweat
Guard (#2 Phillips Screwdriver). Next, slide the Mount
Cap (Item H) into position. Install with the two original
screws.
Pull Caps off Base Studs
Screws (x2)
HOW TO ASSEMBLE THE M3i BIKE
1
3
2
4
Mount Cover
Computer Display
Computer Mount
Cavity
If present, release Shipping
Board from Main Frame
(Tool: 1/2-inch Wrench)
HEAVY OBJECT:
HELP REQUIRED.
TWO-PERSON
PROCEDURE
REAR
REAR
FRONT
FRONT
A
B
Transport Wheels
IMPORTANT:
Do not pull wire,
handle with care.
IMPORTANT:
Do not pull wire,
handle with care.
Mount Screw
Mount Tabs
Computer Mount
Communication
Wire
Mount Screw