Keil MCB517AC, User Manual

Page: 9 / 61

MCB517AC Evaluation Board User’s Guide 3
Chapter 2. Setup
Setting up the MCB517AC evaluation board is easy. The board requires power
and a serial connection to a PC running the MON51 terminal program or dScope
for Windows. Before you start, make sure you have satisfied the following
hardware and software requirements.
Hardware Requirements
n
The MCB517AC Evaluation Board.
n
A serial cable, 9-pin male to 9-pin female, 1-2 meters long, wired one-to-one.
n
A power supply capable of providing 9-12VDC at 300-500mA. The power
cable should terminate with a 5.5mm barrel plug with a 2.5mm center hole.
Plus must be connected to the center hole.
n
A PC with an available RS-232 port. If the port has a 25-pin connector, a
9-pin male to 25-pin female adapter may be required.
n
A device programmer is required to program any EPROMs or other
programmable devices.
Software Requirements
n
The Keil MON51 terminal program (MON51.EXE) or the Keil dScope for
Windows with the MON51.DLL / MON51B.DLL driver.
n
The Keil MON51 software/firmware is already programmed into the EPROM
provided on the MCB517AC board.
n
Microsoft Windows version 3.1, 3.11, Windows 95 or Windows NT.