KEEWAY ATV300, User Manual

Page: 99 / 110

99
BATTERY INSTALLATION
Install the battery in the reverse order of removal.
After installing the battery, coat the terminals with
clean grease.
CHARGING
Firstly, connect the charged positive cable to the battery
positive terminal. Secondly, connect the charged negative
cable to the battery negative terminal.
Using 0.9A-charging current about 11 hours. (Normal charging)
Or using 4A-charging current about 3 hour. (Quick charging)
Keep flames and sparks away from a battery being charged.
Quick charging should be limited to an emergency;
Normal charging is preferred
14.5 ELECTRIC STARTER
Information
If a battery has not work a period of time, the voltage may
reduce and may not provide enough power to starter motor.
If a battery is in a good condition, but engine can not be start.
Please go back to service
TROUBLESHOOTING
Starter Motor Turns Slowly
Weak battery.
Poorly connected starter motor cable.
Failed starter motor.
Poorly connected battery ground cable
Starter Motor Cannot Work
Engine stop switch at “off “position.
Gearshift bar is not at neutral position.
Check for a blown fuse near battery.
Make sure that the battery is fully charged and in good condition.
14.6 LIGHT BULBS REPLACEMENT
HEADLIGHT
To remove the headlight, please loosen three screws at
back of the headlight.
Head light