28
power.
Date/Time Stamp not appearing on images
Make sure that the
″Time Stamp″ parameter is set to ″On″.
Photos Do Not Capture Subject of Interest
1.
Check the
″Sensor Level″ (PIR sensitivity) parameter setting. For warm
environmental conditions, set the Sensor Level to
″High″ and for cold weather
use, set the sensor for
″Low″.
2.
Try to set your camera up in an area where there is not a heat source in
the camera′s line of sight.
3.
In some cases, setting the camera near water will make the camera take
images with no subject in them. Try aiming the camera over ground.
4.
Try to avoid setting the camera up on small trees that are prone
to being moved by strong winds.
5.
Remove any limbs which are right in front of the camera lens.
PIR Sensor LED Flashes/Doesn′t Flash
1.
When the camera is in the
″Setup″ mode, a special LED on the front of the
camera will flash when it senses motion. This is for setup purposes only and
will help the user aim the camera.
2.
During use, the LED will not flash when the camera takes an image. This
is to help keep the camera hidden from game.
LCD Screen Issues
1. LCD screen powers on but no text is present
.
a.
After moving the switch from
″Off″ to ″Setup″ or ″On″, make sure that the
switch is correctly in position to ensure the proper mode (avoid
positions
″between″ two modes).
b.
Do not move the switch directly from
″On″ to ″Setup″ - always move the
switch all the way down to
″Off″ first, then back up to ″Setup″.
2. LCD screen shows a faint black line after turning from
″Setup″
to
″On″.
a.
The LCD will turn off when you slide the switch to the
″On″ position. In some
cases, this black line will appear and then fade in about 1 second. This is
normal and the camera will function properly.
3. Screen comes on but then powers off
a.
Make sure that you have installed the SD card correctly.
