Keenon Robotics Co.,Ltd
15
so that the automatic charge-back interface at the bottom of the robot will contact the charging contact
piece of the charging pile.
⑤
After the contact is successful, the page will display that the connection is successful, and after
waiting for 5 seconds, the page of charging capacity will be displayed.
*
Note:
In the above steps
①
and
②
, the user needs to charge the robot through the charging pile. It is
necessary to ensure that the electric pile is well electrified so that the robot can correctly connect the electric
pile. Please pay attention to the potential safety hazard caused by poor operation.
3.5.3 Adapter Charging
(not recommended; it is forbidden to operate the robot during the adapter
charging process)
When the battery of the robot is exhausted and the machine cannot be turned on, the user can
charge the robot through the adapter in the following steps:
①
Turn off the power switch of the machine.
②
Open the silicone cover outside the back of the robot [Manual Charging Interface], and connect
the robot with the charging plug of the adapter.
③
After successful connection, the adapter indicator will turn red and the screen interface will
jump to the charging page, suggesting that charging is in progress.
④
When the indicator light of the adapter turns green, it suggests that the charging is complete.
Please disconnect the adapter and plug the silicone cover outside the charging interface of the robot.
3.6 Emergency Treatment
When the robot is moving, the user is required to push and move the robot by hand, or when the robot
is in an abnormal running state, which may result in damage to the surrounding environment, etc., the user
can stop the robot by pressing the emergency stop switch on the back of the robot. The position and
operating steps of the emergency stop switch are demonstrated in Figure 5.
