���
Fitting the dividers
훽
Place the
dividing rod supports
as shown, using the
short cap
screws
and
washers
removed earlier, to hold the supports to the
end of the unit.
훾
Offer each
rod
up into the slot (this may be a tight fit -
this stops the
rods
rattling when in use).
훿
Pull the
rods
down and push into the holes in the
base channels
.
���
Fitting the base channels
Slide the
base channels
in place starting
from the outside working towards the
centre. Ensure the set of holes in the edges
are towards the front of the unit.
The two channels on the outside
fit tight to the inside of the
beam
leaving a small
gap at the back of
the channel.
➠
GAP
➠
➠
➠
훽
훾
훿
BEAM
BEAM
LEG
BEAM
NUT
WASHER
WASHER
DIVIDING ROD
SUPPORT
DIVIDING ROD
SUPPOR
T
DIVIDING ROD
SUPPORT
LONG CAP
SCREW
SHORT CAP
SCREW
