���
Fitting the base channels
Place the unit in its final position, once the
base channels
are fitted
the unit can be dragged but not lifted.
Slide the
base channels
in place starting from the outside working
towards the centre. Ensure the set of holes in the edges are towards
the front of the unit.
The two channels on the outside fit tight to the inside of the
beam
leaving a small gap at the back of the channel.
���
Fitting the dividing rod supports &
dividing rods
훽
Fit the
dividing rod supports
inside the
top beams
as
shown, using the
cap screws
and
washers
.
Note:-
ensure the fixing channel is pushed to the back
of the unit.
훾
Offer each
rod
up into the slot (this may be a tight fit -
this stops the
rods
rattling when in use).
훿
Pull the
rods
down and push into the holes in the
base channels
.
➠
GAP
➠
➠
➠
훽
훾
훿
