FOOTSWITCH CONTROLS
Smart Controls at the press of a button
ADVANCED CONTROL
Using the HALO with External Switching
6
REMOTE SWITCHING
The two preset bypass switches can be controlled
remotely through the remote jack. Using a TRS
cable, the tip controls the B switch while the ring
toggles the A switch. The unit is set up to be used
with momentary switches by default. It can be put
into latching mode by holding down the A bypass
switch while applying power to the unit. Doing this
again will put the unit back into momentary mode.
While in latching mode, the bypass switches
on the unit will behave differently than when in
momentary mode. The A switch on the unit will
no longer turn the preset on or off. The B switch
on the unit is tied directly to the tip of the remote
switching jack. Due to this, the on-unit B switch
will act as if it has been hit twice for every one
button press.
EXTERNAL TAP
Plugging a mono cable into the expression jack will
allow the use of an external switch for tap tempo
control. Holding this switch down will also activate
maximum feedback for the active delay.
SIDE A / B
- Tap the A or B footswitch to
activate each side of the HALO. Tap the alternate
footswitch to use the alternate sound stored in
each Preset Bank.
Note: Only one side of each Preset Bank can be
active at a time.
ADVANCING PRESET BANKS
- Hold both Side
A and B stomps for 1/3 of a second to advance
through presets 1-4.
SAVING NEW PRESETS
- Tap the FDBK knob
to enter Preset Mode. The Preset Bank light will
begin to blink. Then hold stomp A or B for 1
second to save your settings to the desired side
of the HALO (See page 8 for more information.)
Summary of Contents for HALO
Page 1: ...INSTRUCTION MANUAL...
