Keeler Pulsair IntelliPuff, Instructions For Use Manual, Page: 14 / 110

10
EN
Pulsair Intellipuff Tonometer by KEELER
12 Demo Button
To reassure the patient, you can demonstrate the procedure, using the Demo button, on the
back of the patient’s hand prior to taking a reading.
13 OD / OS Button ‘Menu Change Button’
This toggles between recording data for the left or right eyes. This button is also used to toggle
through the User Menu Options when in Menu Mode, refer to page 14 for full instructions
on the User Menu Options.
14 Eyepiece
The Eyepiece allows the user to view the patient’s eye and align the targeting system.
15 Puff Tube and Lens
The Puff Tube and Puff Lens are the parts of the Pulsair
IntelliPuff through which the Pulsair IntelliPuff is aligned and
a gentle puff of air is emitted.
16 Alignment LEDs
The two green LEDs located on the front of the Hand Unit act
as a guide when you are lining up the patient’s eye to take
a reading.
8. MEASUREMENT PROCEDURE
8.1 PREPARING THE DEVICE
1. Plug in the Power Supply Cord to
the tonometer. The Power Socket is
located at the rear of the tonometer.
2. Turn the tonometer on using the On /
Off push switch located on the front
of the tonometer.
3. Lift the Hand Unit from the cradle.
4. Remove the red protective dust cap
from the Puff Tube.
5. When the Hand Unit is removed from
the holster the two green LEDs on the
front illuminate, and the pump starts,
the Pulsair IntelliPuff will perform a
system check, when complete the
display will read ‘OK’, refer to Section
9 for a full list of display data.
16
15
3
4
1
5
6
2