Keba KeContact P40, Quick Manual, Page: 3 / 60

EN
2
ATTENTION
!
Possible damage to property!

Pull the charging cable out of the plug holder only by the plug and not by the cable.

When the charging cable is not in use, always plug it into the plug holder or use a suitable plug protective cover.

Do not place or hang any objects on the charging station or plug holder and do not use these as climbing aids.

To clean the charging station, use only solvent-free cleaning agents without anionic surfactants.
Observe the following additional notes when installing the charging station:

If a cold charging station is brought into a significantly warmer environment (e.g. after transport in a cold
environment), condensation may form in the device. Before connecting the charging station to the power supply,
you must wait until the temperature of the charging station is the same as the ambient temperature and the
moisture has evaporated again.

During outdoor installation, the protective cover must not be opened in unsuitable weather (rain, wind, snow,
etc.) unless suitable weather protection is used.

The mounting surface must be level and completely cover the back side of the charging station.

The process of drilling the mounting holes must not damage the installation lines. If necessary, use the
alternative, off-center drill hole.

Choose a suitable tightening torque for the mounting screws that is appropriate for the subsurface; however, the
tightening torque must not exceed 7 Nm.

When connecting and wiring the charging station, ensure that the connection area is clean so that no foreign
objects (pieces of wire, etc.) get inside the charging station.

When installing the charging station, make sure that no pools of water can form during operation.

The charging station must always be fully and properly equipped with seals for the cable openings. If seals of
unused cable openings are cut open, they must be screwed shut with dummy plugs to ensure leaktightness.
General criteria for the site selection

Observe the permissible ambient conditions (see "Technical data" in the Installation manual).

Take into account the local electrical installation regulations, fire prevention measures and accident prevention
regulations as well as emergency routes at this site.

The charging station must not be installed in zones at risk of explosion (EX environment); likewise, areas with
special hazards (flooding, mudslides, avalanches, etc.) must be avoided.

The charging station may only be installed in stationary applications at the prescribed installation heights.

Install the charging station in such a way that charging cables do not overlay or cross any pedestrian paths.

Do not install the charging station at locations where it is exposed to ammonia or ammonia gas (e.g. in or at
stables).

Do not install the charging station at locations where falling objects (e.g. hung-up ladders or automobile tires)
could damage the charging station or the plug holder.

The charging station must not be exposed to direct spray water (e.g. neighboring manual car wash facility, high-
pressure cleaner, garden hose).

If possible, the charging station should be mounted protected from direct rain and sunlight.
Disposal
ATTENTION!
Please observe the regulations regarding disposal of electric appliances and electronic devices.