13
ANTRIEBSTECHNIK
1. Introduction
1.1 About this Manual
Before you start with the installation of the frequency inverter / servo drive, please read
this manual carefully and pay special attention to the notes and suggestions.
This manual contains:
•
safety and warning instructions
•
installation instructions that conform with EMC
•
explanation of the EG directive / CE mark
•
sticker to fasten onto the inverter / servo controller
This manual must be made available to every user. Before working with the unit the user
must become familiar with it. This especially applies to the knowledge and observance
of the following safety and warning indications.
The pictograms used here have the following meaning:
Danger
Warning
Caution
Attention
Essential
Measure
Is used when the life or health of the user is in danger
or considerable damage to property can occur.
Is used when a measure is necesary for safe and
disturbance free operation.
1.
Introduction .............................................................. 13
1.1
About this Manual ................................................................... 13
2.
Safety and Application Instructions ....................... 14
2.1
General .................................................................................... 14
2.2
Use as directed ....................................................................... 14
2.3
Transport, Storage and Installation ....................................... 14
2.4
Notes on installation ............................................................... 15
2.5
Electrical Connection ............................................................. 15
2.6
Operating Instructions ........................................................... 18
3.
EMC Fundamentals .................................................. 19
3.1
General .................................................................................... 19
3.2
Installation ............................................................................... 19
3.3
Installation of an EMC Conform Cabinet .............................. 20
3.4
Explanations ........................................................................... 21
3.5
Connection of the Control Lines ........................................... 22
4.
CE-Marking ............................................................... 22
5.
Manufacturer´s Declaration ..................................... 22
6.
Fastening the Safety Sticker ................................. 123
Table of Contents