40
Error Diagnosis
E.CO1 ERROR counter overrun 1 54 Error: Counter overflow encoder channel 1
E.CO2 ERROR counter overrun 2 55 Error: Counter overflow encoder channel 2
E. BR
ERROR brake
56 Error: This error can occur in the case of switched on brake cont-
rol, if the load is below the minimum load level Pn.58 (application
mode) at start up.
E.INI
ERROR initialization MFC
57 Error: MFC not booted
E.HYBc ERROR hybrid changed
59 Error: Encoder interface identifier has changed, it must be confir-
med over ec.0 or ec.10 (application mode).
E.ccd
ERROR calculation drive
60 Error: during the automatic motor stator resistance measurement
E.OS
ERROR over speed
105 Error: Real frequency is bigger than the max. Output frequency
A.OHI
ABN.STOP overheat int.
87 Warning: overtemperature in the interior
A.nOH no A. overheat pow.mod.
88 Warning: no more overtemperature of power module
A. OH
A.STOP overheat pow.mod 89 Warning: Overtemperature of power module
A. EF
ABN.STOP external fault
90 Warning: external error
A.ndOH no A. drive overheat
91 Warning: no more overtemperature of motor TEMPERATURE
SENSOR. Motor SENSOR is low-resistance again.
A.nOHI no A.STOP overheat int.
92 Warning: no more overtemperature in the interior
A.buS
ABN.STOP bus
93 Warning: Watchdog for communication between operator/control
card has responded
A.PRF ABN.STOP prot. rot. for.
94 Warning: locked direction of rotation clockwise
A.PRR ABN.STOP prot. rot. rev.
95 Warning: locked direction of rotation counterclockwise
A.dOH ABN.STOP drive over heat 96 Warning: overtemperature of motor TEMPERATURE SENSOR
A.OH2 ABN.STOP motor protect.
97 Warning: electronic motor protective relay has tripped
A.nOL no ABN.STOP overload
98 Warning: no more overload, OL counter has reached 0 %.
A. OL
ABN.STOP overload
99 Warning: Overload can only be reset at A.nOL, if OL counter has
again reached 0 %
A.OL2 ABN.STOP overload 2
100 Warning: Overload can only be reset at A.nOL2, if cool-down time
has elapsed
A.nOL2 no ABN.STOP overload 2 101 Warning: no more overload, the cool-down time has elapsed.
A.SET ABN.STOP set
102 Warning: set selection: It has been attempted to select a locked
parameter set.
