11
VI SERVICE DIAGNOSIS
A properly adjusted Keating Incredible Frying Machine (IFM), with no load, will cycle “On” approximately every 2-
1/2 to 3 minutes. Each cycle will last 15 to 25 seconds, ensuring that the temperature setting is held within a
narrow band.
l
Every Keating Incredible Frying Machine (IFM) has a number of safety controls to ensure safe
operation and guard against component failure.
A. Trouble shooting chart
The following diagnosis is only to be used as a guide to qualified service personnel. Keating recommends that you
use a qualified service company. Call 1-800-KEATING if you need assistance in locating a qualified service company.
NOTE:
To correctly and quickly diagnose the system, the chart below must be followed in sequential order.
PROBLEM
PROBABLE CAUSE
SOLUTION
Main power light does not
a. Fryer not plugged in.
a. Plug fryer into approved outlet.
come on.
Must be properly grounded.
b. Breaker has tripped.
b. Reset the breaker located on the
bottom of the control panel.
c. Main power switch is faulty.
c. Replace the main power switch.
Blower light does not
a. Thermostat not turned on.
a. Set thermostat to desired temperature.
come on.
b. If blower comes on, blower
b. Replace blower light.
light is faulty.
c. If Over Maximum Temperature
c. Reset Hi-Limit after oil has cooled
light is on, Hi-Limit has
down below 425°F. Correct problem
been activated.
which caused Hi-Limit to activate. (See
page 9)
d. If blower does not come on,
d. Verify power to blower light and blower or
spark ignition module is faulty.
replace the module.
Solutions (Follow Sequentially)
Contact service agent to verify
proper gas pressure.
Calibrate the thermostat by rotating
the dial plate to match the actual
temperature of the oil.
Do not over fill baskets with food.
Do not overfill fryer with oil (check
the fill level stamped into the fry
pot).
Probable Cause
Gas pressure incorrect.
Thermostat not calibrated.
Overloading fryer.
Common Problems
5. Not recovering
Summary of Contents for SERIES 2000
Page 24: ......
