5.Equipment Required for Assembly
Agile Helicopter is a Trademark of Flight Research Rc Europe , Proudly made by KDS Model Shenzhen
Page 03
RADIO TRANSMITTER AND ELECTRONIC EQUIPMENT REQUIRED FOR ASSEMBLY
6.Package Illustration
The first level: all CF parts
Tail boom x1
Drive shaft(torque tube) x1
Tail boom brace x2
Tail pitch linkage rod x2
Skid pipe x2
Metal parts of main Rotor Head x1
Metal parts of main frame x1
Metal parts of Tail Unit x1
Screws bag
Colorful painting canopy x1
Main blade holder x1
Landing skid x2
•Brushless electric motor: 12s Lipo - 500~550KV / 3000W
(4mm Bolt holes, 30mm mount width, 6mm * 37mm motor shaft)
•Speed controller: minimum 120A
(ESC specs limits should be rated accordingly to the maximum amps handling by the motor)
•Lipo Batteries: 12s 4000-5500 mAh
•Electronic flybarless system
•3 cyclic servos, standard size
•1 tail rotor servo, standard size, high speed required
•690~720 mm main rotor blades
•105~115 mm tail rotor blades
(
included)
•6 channel or more helicopter transmitter system, 2.4 Ghz frequency preferred
•Receiver 6 channel or more (working with your transmitter specs)
“A” Glue width: approx. 2mm
2mm
“
OIL
”
Lubrication grease
. “
A
”
thread lock
,
apply a
small amount on screws or metal parts and wipe surplus off. When disassembling,
recommend to heat the metal joint about 15 seconds
. (
NOTE
:
Keep
plastic
parts
away
from
heat
.
)
When you see the marks as below, please use glue or grease to ensure flying safety.
