- 9 -
Pocket Pager
Insert the pager provided into the slot located on the front bottom right side
●
Installation
of the unit. Insert with magnet side in. The top/bottom configuration is not
important.
Note There is a magnetic latch inside the slot. Make sure to insert fully and engage the
)
magnetic latch.
Power On
■
Turn the power on after machine setup.
1. Turn the switch on the front right side of the unit upward to power on. After
is displayed, an existing muffle temperature appears to show the
unit is in correct condition for operation.
2. The READY lamp of pager will blink to charge the pocket pager. With the
pager fully charged and the unit in melting mode, the lamp is illuminated
P17
when time data up to the end of melting is stored in the pager.
→
Note Even after the pager is fully charged, the lamp will continue to blink if melt button is
)
not pressed.
Note If the pager battery is completely discharged, the lamp will take approx. 10 seconds
)
before it starts blinking.
3. If the Start Temp has been programmed, it will start heating up toward the
Start Temp.
THIS IS CALLED STANDBY MODE
Note At low temperatures the unit may make a low buzzing sound during heat up. This is
)
the sound electricity flowing through muffle heater. This is normal.
Note If
is displayed on the 4 digit display, open the chamber lid to prevent the
)
chamber lid from overheating.
Stand-by Mode
■
The following modes are available to be switched from Standby Mode.
1. Program Mode
Casting parameters are programmable in both auto and manual program
mode. Program checks and modifications are also available.
2. Melting Mode
Alloy melting mode for casting.
3. Casting Mode
Cast melted alloy into a mold.
4. Duplication Mode
Enables you to copy the program on display to other program course
desired. This will help simplify the creation of similar program.
5. Default Value Set Mode
Enables you to set Pager sound volume, +Temp value and Altitude.
We will cover each mode as described below.
How to Program
■
Two methods of programming are provided as follows ;
1. Auto Program Mode
The inputs of alloy liquid phase temp, alloy quantity, investment type and
crucible type will automatically program the 5 casting parameters.
Note This auto program mode is not 100% infallible. Depending on castings at hand
)
when you are in need of adjusting each parameter, we recommend you to make
adjustments to the parameters as required on the manual program mode.
