Armrest Adjustment
The height and position of the armrest can be adjusted as follows:
1. Up and down adjustment: As shown in Fig. H1 and Fig. H2, press the adjusting button, then you can move the armrest
up and down. Once you release the button, the position will be locked.
2. Front and rear adjustment: As shown in Fig. H3 and Fig. H4, press the adjusting button, then you can
move the armrest back and forth. Once you release the button, the position will be locked.
。
。
。
26
27
Backrest Adjustment
/
Controller
Armrest Adjustment/Backrest Adjustment
★
Notes:
1. It is prohibited to drive the motor when the backrest is adjusted to a lower
position to prevent the wheelchair from tipping over.
★★★
2. It is prohibited to adjust the backrest on the slope to prevent the wheelchair
from tipping over.
★★★
3. When the backrest cannot be adjusted by pinching the adjusting button, please contact the
distributor to adjust the tightness of the traction lock.
1
2
3
4
1
2
3
4
H5
H6
Backrest Adjustment
The backrest can be adjusted by the adjusting button as follows:
1. As shown in Fig. H5, Press the backrest adjusting button and gently press the backrest. When it
reaches the proper position, release the button, and the backrest will be locked.
2. As shown in Fig. H6, Grasp the armrest and straighten the back. Then, press the adjusting button,
the backrest will be reset. Or you can release the adjusting button at any position and once you
release the button, the position will be locked. (Note: The backrest can be adjusted when the back
button is pressed.)
H1
H2
H3
H4
Controller
There are four external interfaces for controllers in all, which are described in detailed as follows:
1. Interface 1 is for the right-side motor interface. When the right motor fails to drive, please check if the
right-side interface is tightened.
2.
I
nterface 2 is for the power interface. If the circuit is abnormally powered off, please check if the interface
is in poor contact, and tighten the securing ring.
3. Interface 3 is for the left-side motor interface. When the left motor fails to drive, please check if the left-
side interface is tightened.
4. Interface 4 is for the joystick interface. When the current fails to input, please check if the interface is in
poor contact, and tighten the securing ring.
