高宝印刷机械科技有限公司
KC Printing Machine (group) limited
28-8
Website: Http://www.dg-padprinter.com
Online contact Skype: yingsuhuakelven
QQ: 726986799
Email:
[email protected] [email protected]
五、参数的设置与调整
Setting and adjusting Parameter of Stamping process
1、温度的设置：
Temperature setting
（参见智能温度仪的有关事项）不同的烫印材料，要有不同温度与烫印箔，应根据材质温度所需设置好温度。
(See also temperature controller), different stamping materials , setting different stamping foil and
temperature.
2、时间的设置：
Time setting
烫印调时与卷箔调时设置方法相同，设置时应在通电时设置，例如：“44s38”，表示 44.38 秒，“M”为分钟，“H”
为小时，“22H12”为 22.12 小时，本机出厂设置为“S”秒。
It is same between adjusting stamping testing and foil collecting testing. Please set them when power supply
connect . For an ample: “44s38” meaning 44.38 seconds, “M” instead of minutes, “H” instead of Hour,
“22H12”meaning:22.12 hours. The machine set as “seconds” out of factory.
3、工作压力的调整：
Pressure adjustment
本机为杠杆传动，调整压力时将加热模板与工作台紧密接触，用手旋转工作台下方手柄，使丝杆上升，上升到 3-4mm
左右时，产生的压力即为设备的最大压力，用户应根据烫印件选择合适的参数。
烫印时若压力过小，应旋转手柄使丝杆上升（缩短工作行程），若压力过大，应旋转手柄，使丝杆下降（增加工作
行程）。
The pressure generated from Level cylinder installed on stamping head. Please rotate the handle below the working
table and rise it up for 3-4mm with hands when stamping plate contact with working table. The pressure too small, rotate
the handle and make screw mandrel rise up; the pressure too big, rotate the handle and make screw mandrel down.
4、电化铝的安装与调整（见下图）
Install foil
A
B
C
