KBL megaSun Tower Optima, Operating Instructions Manual

Page: 37 / 48

O p e r a t i n g I n s t r u c t i o n s | megaSun Tower Optima
37
To install the pane, insert its entire left-hand side and
press it against the aluminium section.
Bend the pane and push it over the right-hand edge
of the aluminium section. Due to the pane being
bent, it rests in its position.
Tubes
By regularly cleaning the tubes (see Cleaning and
care instructions) you can help preserve their tanning
power. When replacing the tubes, you must also
replace the starters. Replace tubes and starters only
against ones of the same type. The colour filter of the
tanning device lighting must be replaced whenever
the tube is replaced.
Dismantle the acrylic panes as it is described in the
section “Cleaning and replacing the acrylic panes”.
Dismantle the tubes by turning each tube a quarter
turn towards the front or towards the back and then
pulling it out.
To clean the tubes, use warm water and a chamois.
Do not use any aggressive detergents or agents con-
taining alcohol.
When installing new tubes, replace the starters first.
Installing the tubes: Make sure that the inscription
on the tubes is visible, for otherwise, there will be no
tanning effect.
The assembly is carried out in reverse order. Reset
the operating hours counter in the service menu.
Collagen boosters
In the case of a defect, replacement can only be
made by qualifi ed technical personnel. Contact your
service partner in this case.