KBL MegaSun 7000a, Operating Instructions Manual

Page: 7 / 52

O p e r a t i n g I n s t r u c t i o n s | megaSun 7000/7800 alpha
7
Old equipment disposal
This tanning device consists of
components that cannot be thrown into the
household garbage!
Dispose of your old equipment in an environmentally
friendly manner after the end of its useful life. Metals
and plastics can be recycled. Electrical and elec-
tronic components must be disposed of as e-waste.
Fluorescent lamps must be dropped off at authorized
collection points for pollutants.
This helps to avoid damaging effects to the envi-
ronment and human health caused by improper
disposal.
This makes a valuable contribution to recycling and
other forms of utilization of old electrical and elec-
tronic equipment.
You can obtain information about environmentally
friendly disposal from your local government or the
municipal administrations.
CAUTION
Risk of mercury toxicity
Risk of mercury toxicity after a lamp
breakage.
• Ventilate the room / environment at least
15 minutes before disposing the lamp
fragments.
Setup location
Operation only in dry rooms with sufficient airing and
ventilation.
Do not operate the tanning device in
locations with aggressive environmen-
tal conditions (e.g. salty air or air con-
taining chlorine).
DANGER OF OVERHEATING BY OBSTRUCTION
OF THE AIRFLOW
Avoid in any case a change, obstruction or block-
age of the air inflow and outflow area to the tanning
device or to make any unauthorized changes to the
tanning device. The manufacturer shall bear no liabil-
ity for damage or injuries resulting from such actions.
• Maintain the minimum distances from ceiling, bot-
tom and the walls! Dimensions are given in chapter
technical data.
Insufficient air supply leads to overheat-
ing which may result in damaging the
tanning device!
OPERATION IN MOBILE FACILITIES
CAUTION
Crushing hazard caused by sudden
movements
The tanning device is unsuitable for oper-
ation in mobile facilities (buses, trains,
ships).
• The tanning device must be adapted
in order to ensure trouble-free oper-
ation when used in mobile facilities.
DIFFERENCE IN TEMPERATURE
Risk of damage by switching on the
power supply voltage.
When there are great differences in tempera-
ture between the transportation route and the
installation site the tanning device shall not be
put into operation immediately after being set
up.
• Before connecting the tanning device
to the power supply, wait at least for
2 hours.
Service
For all service-related questions, please contact your
responsible specialist dealer.