O p e r a t i n g I n s t r u c t i o n s
|
megaSun 7000/7800 alpha
15
Start-up
Commissioning is performed by the manufacturer or
qualified, trained and authorized service technicians.
The tanning device is operational on delivery.
As the studio operator, you are responsible for com-
pliance with the electrical regulations applicable at
the installation location.
If the tanning device has not been used for an
extended period of time, it has to be inspected by
qualified, trained and authorized service technicians
before it is put back into operation.
BEFORE SWITCHING ON FOR THE FIRST TIME
• Fix the supplied warning sign or one with the
following wording permanently to the wall close to
the tanning device:
Warning
• UV-radiation can cause eye and skin damage as
well as skin aging and possibly skin cancer. Ask
the studio staff for further information.
• Wear protective goggles.
• Certain medicines or cosmetics can increase the
sensitivity of the skin to UV radiation. If in doubt,
consult a physician.
• Determine the pre settings for the tanning device in
the service menu.
• Check correct installation of fluorescent tubes. The
tube labelling must be visible, otherwise no tanning
effect may be obtained.
• Store these Operating Instructions in a place that
allows for easy access at any time.
Operating modes
STANDBY MODE
The tanning device is in an idle state, i.e. it is
connected to the mains but is currently not being
used. The tubes and the tanning lamps are switched
off. From the standby mode, you can change over to
the tanning mode or to the service mode.
TANNING MODE
The tubes and the tanning lamps are switched
on and a tanning session is in progress. While the
tanning device is in tanning mode, the settings for
the ongoing tanning session can be changed via the
interior control panel.
SERVICE MODE
In the service mode, the tanning device is configured
for the tanning mode. Various values can be displayed
and test functions can be carried out.
FAN RUN-ON
After the tanning session, the fan runs on for 3
minutes in order to cool down the tanning device.
The fan power is automatically decreased as the
tubes cool down.
Summary of Contents for MegaSun 7000a
