A s s e m b l y I n s t r u c t i o n s
|
6808 /7908
13
• Move the complete bench pane slightly to the left
so that the right pin is also free.
4.4.3 LIFT OUT BENCH PANE
• Grab hold of the bench pane on both sides and lift
it up to the maximum height (20 mm distance to
the canopy) and lift it out of the rear guide profi le
in
this position
.
Be careful when removing the bench pane.
When the bench pane is lifted out, it can
bump against the canopy.
• The distance between canopy and
bench pane may not be less than
20mm.
20mm
• Transport the bench pane to the installation site
and set it down safely on protective padding.
4.5 Remove front panel
PH2
4.5.1 INSTALL CANOPY PANE (TEMPORARILY)
Safety measures to protect the tube
section of the canopy.
• Make sure that the control panel cable is
not caught or pinched.
4.5.2 REMOVE SIDE PANELS – 7908
ONLY
• Pull the two acrylic panels of the decorative lighting
of the bench out to the sides.
4.5.3 OPEN THE BENCH
4.5.4 REMOVE FILTER ELEMENT (RIGHT)
