KaVo MASTERmatic LUX M10 L, Instructions For Use Manual, Page: 12 / 26

Instructions for use MASTERmatic LUX M10 L - 1.009.3570
5 Operation | 5.4 Remove the handpiece or contra-angle handpiece drill bit
12 / 26
WARNING
Use of unauthorised cutters or grinders.
Injury to the patient or damage to the medical device.
▶ Observe the instructions for use and use the cutter or grinder properly.
▶ Only use cutters or grinders that do not deviate from the specified data.
CAUTION
Injury from using worn drill bits or burs.
Drill bits or burs could fall out during treatment and injure the patient.
▶ Never use drill bits or burs with worn shafts.
CAUTION
Injury hazard from cutters or grinders.
Infections or cuts.
▶ Wear gloves or fingerstalls.
CAUTION
Hazard from defective chucking system.
The cutter or grinder could fall out and cause injury.
▶ Pull on the cutter or grinder to check that the chucking system is okay and the
cutter or grinder is securely held. When checking, inserting and removing, use
gloves or a fingerstall to prevent an injury or infection.
▶ Rotate the clamping ring all the way in the direction of the arrow, and insert the
handpiece cutter or grinder into the chuck.
▶ Turn the clamping ring back into its initial position.
▶ Check that the cutter or grinder is seated by pulling on it.
5.4 Remove the handpiece or contra-angle handpiece drill bit
WARNING
Hazard from rotating cutter or grinder.
Lacerations and damage to the chucking system.
▶ Do not touch the cutter or grinder when it is rotating!
▶ Remove the cutter/grinder from the contra-angle handpiece after treatment to
avoid injury and infection when putting it away.
▶ After the cutter or grinder has stopped rotating, turn the clamping ring in the direc‐
tion of the arrow to the stop.
▶ Turn the clamping ring back into its initial position.
5.5 Conversion for contra-angle handpiece drill bit
Note
The handpiece must be converted to use contra-angle handpiece drill bits.
▶ Open the handpiece chuck.
▶ Insert the enclosed drill stop in the chuck.