Operating Manual
Original Operating Manual
11
Hoist the attachment at the positions indicated (1).
Demount the lower hooks (2).
Mount the attachment on the fork carriage of the lift truck (3).
Check that the attachment is correctly seated in the centre lock (4).
Mount the lower hooks (2), tightening the screws (5) with a torque of 190 Nm.
Replace the plug screw (6) in the gear box with the vent screw supplied.
Connect the hose lines (7) to the hydraulic connectors on the lift truck.
Trucks equipped with attachments which hold the load by power (e.g. paper clamp) shall
feature control(s) with a secondary action to prevent unintentional release of the load. Also
take note in this respect of the operating instruction of the lift truck.
Before initial operation, check the functions and the identification of the attachment with the
movement directions of the operating elements (operating lever, joystick, etc.).
Mount the residual carrying capacity notice and identification of the operating elements (if
not already present) of the combination of lift truck/attached equipment on the lift truck.
4.2
Checking out
KAUP-attachments are delivered pre-lubricated. If the attachment has been in storage
for a longer period, we recommend that it be lubricated again before being placed in
service. See 6. Maintenance and onwards.
Failure of the safety devices (e.g. the pressure relief valve and the non-return
valve) and incorrect connection of the controls to the actuators can cause
malfunctioning of the attachment and damage to it.
After mounting and before initial operation, check the functions and the
identification of the attached equipment with the movement directions of the
operating elements (operating lever, joystick, etc.).
4.2.1 Bleeding the hydraulic system
Start the lift truck.
Move the sideshifter repeatedly in both directions to maximum extent.
Rotate the rotator left and right several times.
Repeatedly cycle the clamp from the fully open to the fully closed position.
Inspect the hydraulic connections for leakage.
