4 / 14
Main Menu
E1
1236
MHz
TP
27.500
MS/s
3/4
QPSK
Outp.
S21
306.00
MHz
8
MHz
QAM64
The
DiSEqC
TM
controller
for a matrix can be set in the
sub-menu
for the input socket that was selected.
Press the “Sub-menu” button
to activate the sub-menu; press the “Sub-menu” button
again to deactivate it.
1.3 DiSEqC
TM
setting
Sub-menu for channel unit I
***
UFO333MX
***
Input
A
DiSEqC-A
Off
DiSEqC-B
off
Select the desired level using the “+” and “-” buttons. The following settings are available:
DiSEqC
TM
-A or -B
off
The
DiSEqC
TM
controller is switched off
Ver-Low-1
In connection with a matrix: Vertical low band position 1
Hor-Low-1
In connection with a matrix: Horizontal low band position 1
Ver-High-1
In connection with a matrix: Vertical high band position 1
Hor-High-1
In connection with a matrix: Horizontal high band position 1
Ver-Low-2
In connection with a matrix: Vertical low band position 2
Hor-Low-2
In connection with a matrix: Horizontal low band position 2
Ver-High-2
In connection with a matrix: Vertical high band position 2
Hor-High-2
In connection with a matrix: Horizontal high band position 2
Main Menu
E1
1236
MHz
TP
27.500
MS/s
3/4
QPSK
Outp.
S21
306.00
MHz
8
MHz
QAM64
Note:
When the DiSEqC
TM
controller is switched on, a DC voltage of approx. 12 V is present at the input sockets!
If no matrix is used, the DiSEqC
TM
controller cannot be switched on.
The DiSEqC
TM
controller can be set up only in the sub-menu for the input tuner 1 (E1). The selected information available in the
sub-menu for the input tuner 2 (E2) is displayed solely for information. It cannot be selected there. The DiSEqC
TM
controller applies
to both E1 and E2. Each of inputs A and B can be plugged into either input tuner.
1.4
Selecting input frequency
The
input frequency
in the active channel unit is selected using the “<” and “>” buttons. The input frequency can be set continuously
from
950 MHz to 2150 MHz
in 1 MHz steps using the “+” and “-” buttons.
Main menu (example for digit-by-digit setting)
E1
1
236
MHz
TP
27.500
MS/s
3/4
QPSK
Outp.
S21
306.00
MHz
8
MHz
QAM64
The setting can also be made on a digit-by-digit basis:
• Press the “Change setting mode” button
(starts the mode)
• The
fi
rst digit
fl
ashes and can be input directly using the numeric pad on the keyboard
• After the
fi
rst digit has been input, the second
fl
ashes, and so on
• To make a correction, press the “Back” button to skip one place to the left
• After the last digit has been set, press the “Change setting mode” button
to end the mode.
The current
SNR
and the automatically detected
operating mode, DVB-S or DVB-S2
of the front end are displayed in the
input
frequency sub-menu
.
Press the “Sub-menu” button
to activate the sub-menu; press the “Sub-menu” button
again to deactivate it.
Summary of Contents for UFO 333/MX
Page 71: ......