19
SAT
At a level > 120 dBµV the LC display indicates an overfl ow. The
following details are displayed:
• Frequency: 1508.0 MHz
• Operating mode: SAT analogue
• Level: Overfl ow
The level of DVB-S(2) signals can only be measured properly with
the setting “SAT digital reception”.
Note
“SAT DVB-S(2)” LEVEL MEASUREMENT
LC display during DVB-S(2) level measurement:
For how to switch from analogue to digital level measurement
please see “SAT analogue / DVB-S(2) switch”.
• Frequency: 1236.0 MHz
• Operating mode: SAT digital
• Measured level: 86.5 dBµV D
LOCATING SATELLITES
The
[SAT FIND]
function allows you to search for satellites whose
transponder frequencies are unknown. The frequency range from
1000 to 2100 MHz is continuously scanned for reception signals. If
a reception signal is detected, the reception level is indicated in the
display in the form of an increasing or decreasing bar. The
[<] [>]
buttons allow you to set the measurement range to three sensitivity
levels.
A bearing sound enables you to monitor the level. The pitch of
the bearing sound is proportional to the received signal level. The
volume of the bearing sound can be adjusted using the
[Vol-] [Vol+]
volume buttons.
Command overview for [SAT FIND]
[SAT FIND]
Switch to the “frequency-independent satellite
search” mode.
[<][>]
Switch the measurement range, the bar graph and
the bearing sound:
Level range 1: Large input levels
Level range 2: Medium input levels
Level range 3: Small input levels
[SAT FIND]
Exit this mode
LC display:
• Level range 2: Medium input levels
• SAT mode
• Bar graph display with bearing sound
