20
SAT
Example
Launching the “Find satellite” function:
• Press the
[SAT FIND]
button.
• Turn the antenna until a level tendency can be seen on the bar
display.
• Turn the antenna until the bar display reaches its maximum
• If necessary, decrease or increase the sensitivity using the
[<]
and
[>]
buttons.
• Press the
[SAT FIND]
button to exit this function.
FINDING INDIVIDUAL RECEPTION FREQUENCIES
The
[LEV]
function allows you to adjust the antenna to the maximum
reception signal. The display indicates the reception in the form of
an increasing or decreasing bar. The
[<] [>]
buttons allow you to set
the measurement range to three sensitivity levels.
The bearing sound enables you to monitor the level. The pitch of
the bearing sound is proportional to the received signal level. The
volume of the bearing sound can be adjusted using the
[Vol-] [Vol+]
volume buttons.
Command overview for fi nding
[LEV]
Switch to “Find” mode.
[<] [>]
Switch the measurement range, the bar graph and
the bearing sound:
Level range 1: Large input levels
Level range 2: Medium input levels
Level range 3: Small input levels
[LEV]
Exit this mode
LC display:
• Level range 2: Medium reception level
• SAT mode
• Bar graph display with bearing sound
Example
Launching the “Find level” function:
• Press the
[LEV]
button
• Turn the antenna until the bar display reaches its maximum
• If necessary, decrease or increase the sensitivity using the
[<]
and
[>]
buttons
• Turn the antenna until you have reached the maximum level.
Exit
“Find level”:
Press the
[LEV]
button.
