12 of 52
Installation and Connection
5
Installation and Connection
5.1
Installing and Connecting the Turntable
5.1.1 Required Tools and Equipment
●
Circular cutter, Ø 38 mm
●
Flat-bladed screwdriver for M5 screws
●
Power drill
●
The following screws, depending on the roof structure:
–
galvanised round head screws, Ø 5 mm, sheet metal
screws D 7981 or
–
round head screws D 7985 with washers and nuts
●
Twist drill, Ø 2.5 or 5.5 mm
●
Round file and/or emery paper
●
Cleaning agent
●
Open-ended or ring spanners 10 and 11 mm across flats
●
Knife
●
Cross-head screwdriver for M3 and M5 screws
●
Torque wrench capacity 6 to 11 Nm
●
Hexagon socket key, 5 mm
●
Two wooden beams for supporting the turntable
5.1.2 Unpacking and Preparing
WARNING
Risk of injury due to the heavy weight of the package
!
The turntable together with the parabolic reflector weighs close to 20 kg.
►
If necessary, please seek help from a second person when unpacking and installing the turntable.
NOTICE
Risk of material damage during transportation!
►
Never pick up or carry the turntable by the planar antenna.
Unpacking the Turntable
1. Pull the turntable out of the packaging as shown in the illustration below.
2. Remove the packing pieces from the turntable
①
before transporting it to the roof of the vehicle.
3. Loosen the 6 fastening screws (spanner size: 10 mm) which attach the turntable to the mounting plate.
4. Carefully lift the turntable off the mounting plate and place it onto the two prepared wooden supports. When doing
this, make sure that the cables are not crushed where they emerge from the underside of the turntable.
1
Tip
Retain the original packaging, because if it is necessary to send the unit for repair, transport damage cannot
be ruled out and the manufacturer accepts no liability for possible damage.
Summary of Contents for MobiSet 4 Twin CAP 950
Page 43: ...43 of 52...
Page 50: ...50 of 52 Declaration of Conformity 15 Declaration of Conformity...
Page 51: ...51 of 52...
