32 of 56
Polarisation Setting
8.2
Safety Instructions
WARNING
►
Follow general safety instructions; see
Safety Instructions and General Guidelines
, p. 7.
NOTICE
Risk of material damage due to obstacles in the range of rotation or incorrect setting!
►
Make sure that there are no obstacles in the CAP system range of rotation.
►
Do not set the LNB yourself if you are not familiar with the setting operations. Contact a technician or try
to find a suitable person on the campsite.
8.3
Setting Operations
The following description assumes that the complete CAP unit has been properly assembled, installed and set up as
described in the previous sections.
✔
The CAP converter is disconnected from the mains.
1. Unscrew the fastening screw of the clamp on the LNB using the socket driver supplied (Torx, size 20).
2. Rotate the LNB by the required number of degrees. The scale is located on the bottom on the LNB; see the figure
below.
3. Tighten the fastening screw to a torque of 3.3–3.5 Nm.
4. Leave the installation location.
5. Reconnect the receiver to the power supply.
6. Switch the CAP converter on using the on/off switch.
➯
The system is ready for operation.
Scale for polarisation
setting
