25 of 56
5.2.6 Laying the Cables and Connecting the Turntable
NOTICE
Risk of damage to cables from sharp edges and chafing points!
►
Do not lay cables across sharp edges.
►
Protect cables against possible chafing points.
1. Connect the master coaxial cable (marked red) to the CAP converter and the slave coaxial cable to a second TV with
a built-in receiver or a second receiver (if available).
Tip
If you do not use a second receiver, we recommend attaching the slave coaxial cable nonetheless, in case
you might need it at a later time.
2. Lay the turntable power supply cable (3-pin plug) to the battery. If necessary, use the power supply extension cable.
3. Connect the master coaxial cable to the
IF INPUT
socket at the rear of the CAP converter. If necessary, use the coaxial
extension cable.
5.2.7 Connecting the CAP Converter
WARNING
Risk of severe injuries due to cable fire
!
If you remove or bypass the fuse in the cable, it can cause cable fire.
►
Do not remove or bypass the fuse in the cable.
NOTICE
Risk of material damage due to incorrect supply voltage!
At the connecting point for the power cable, the voltage must not fall below 10.9 V even with a load of 12 A.
Otherwise, optimum functioning can no longer be guaranteed.
►
Connect the CAP converter to no other power supply than 12 V.
►
Connect the earth pole of the CAP converter to the negative pole of the motor home or caravan battery.
NOTICE
Risk of material damage due to the absence of a blade fuse in the cable!
►
Protect the positive wire (red) of the power supply cable by using a 15 A blade fuse.
►
The fuse must be installed by a specialist.
►
If the fuse is blown, replace it by a fuse of the same rating (15 A).
►
Eliminate the cause of the fault.
NOTICE
Risk of malfunction and material damage due to reversed polarity!
When connecting the power cables, reversed polarity can lead to thermal overload and damage to compo-
nents when the equipment is powered up. If the earth of the ignition signal and the earth of the vehicle battery
for the turntable do not have the same potential, the automatic antenna lowering does not function!
►
When connecting the power cables (CAP converter and turntable) to the vehicle electrical system, make
sure that the poles are not reversed.
►
Make sure that the earth of the ignition signal and the earth of the vehicle battery for the turntable have the
same potential.
