13
936.2332
/E
/0905
/1
3.1
6
e
Submenu name
Submenu ID
The network ID must only be set if the operator applied for it at ETSI and after it was granted.
The present value (FF01) is for networks without special ID.
Network ID setting should only be effected by adding “
+
” or taking away “
–
” signs from the third (name) line with the
flashing cursor. The maximum number of signs is
40
. The selection of the sign to be added is effected in the first two lines
with the keys “<” “>” withe cursor movement.
The network ID is to be entered digit by digit with the (< >) keys and changed with the (
+
) or (
–
) keys.
The value is taken over on exit from the submenu by pressing the key.
Settings for cable NIT
Submenu cable NIT
Submenu cable NIT
After the building procedure was manually started with the key “
+
”, the control unit takes over the complete NIT
build-up. The new cable NIT will be established and then transmitted to the TP channel units (UFO 386/ TP). Truncation
of the procedure is possible with the rhomboid key . A band display will be shown in the lower line of the display
during the build-up period.
The generated cable NIT can be switched on or off as needed.
Building up of the cable NIT, submenu
Submenu Cable NIT
Submenu Cable NIT
Display in case of truncation :
A B C D E F G H I J K L M N O P Q R S
T U V W X Y Z 0 1 2 3 4 5 6 7 8 9 _
KATHREIN WERKE KG_
Network ID:
F F 0
1
* * * *
Cable NIT
* * * *
NIT
ON
Build up
Network
Name
ID
< Return:
Submenu >
Cable NIT is
being built up
please wait
❚❚ ❚❚ ❚❚ ❚❚
....
Switching on the cable NIT:
Requirements for a successful build-up of NIT:
●
Installation of the reception system
must have been fully completed.
●
The reception system must have been
fully adjusted.
●
All TP channel units must be
operational and locked in place.
* * * *
Cable NIT
* * * *
NIT
ON
Build up
network
Name
ID
< Continue:
key >
NIT error:
Operator truncation
< Continue:
key >
