Installation of the HMD Cable Management (Giveaway) :
First Use of KAT Walk Coord 2 Core
Sensor Installation
The sensors should be mounted on bottom of the dedicated shoes.
Wired HMD Cable Management
- Locate the HMD cable 1.5 meters away from the HMD.
- Wrap the Velcro end tightly around the cable (fuzz-side
face-in).
- Thread the USB end through the fixing loop.
- Stick the cable management clip to the top of the upper
shell.
Pull up the Cable
- Peel off and stick the fixing loop on the ceiling
directly above the device.
- Stick the fixing loop on the nearby wall (higher than
the device) and reconnect the USB to the PC.
- Squeeze to open the cable management clip, and
insert the cable into it.
- Hang the HMD on Top.
Identify the Sensors
-Identify the paired L sensor
(L light on), and find the L
Shoe. Vice versa.
*
Light Status:
Off: Sleep/Unpaired/Low Battery
Flashing: Disconnected
Constant: Connected
Flashing: Charging
Mounting the Sensors
- Logo-side faces outside. Insert
the sensors into the
corresponding shoe sockets.
- Incorrect mounting will affect
their operation.
-Note: Before using, ensure the
surface of the shoe sensor is
clean and free of dust. Use a
brush to clean it if needed.
Incorrect Mounting
- The sensors must be installed
exactly as shown in the previous
step.
- Incorrect mounting of the sensors
will affect their operation.
- If needed, use flat-head
screwdriver to pry off the sensor.
17
Summary of Contents for KAT Walk Coord 2 Core
Page 28: ...www kat vr com...
